What AnchorDogs are

SYS-GRP AnchorDogs let you fasten SYS-GRP components (like BenchGrip pods), jigs, and fixtures into a doghole work surface from the top, without reaching underneath the bench.

They are designed for:

• Faster setup and repositioning
• Cleaner workflows on benches where underside access is blocked
• Repeatable placement when you are moving pods and fixtures often

Compatibility

Works with:

• Doghole work surfaces (20 mm and other doghole systems where the AnchorDog fits correctly)
• BenchGrip pods and other fixtures that use an M6 fastener

Fastener note:

• Use the supplied M6 fastener, or any M6 fastener that is the correct length for your fixture and work surface thickness.

How to use AnchorDogs

1. Place the AnchorDog into the desired doghole.
2. Position your fixture (BenchGrip pod, jig, or other accessory) over the hole.
3. Insert the M6 fastener through your fixture and thread it into the AnchorDog.
4. Tighten until you feel resistance. You are seating the AnchorDog and clamping the fixture to the surface.
5. Verify stability with a light wiggle test before starting work.